suppose we using 3 phase motor of 440 v means what range of
C.T. is require for measuring current , the rating of motor
is 1HP ?
- 5 Answers
- 8308 Views
- I also Faced
- E-Mail Answers
Answer Posted / navmit bhimani
CT is requirted for capacity above the range of ammeterlike
Above 20 HP.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
Why r u using pf panel. what the uses
Who many reason of ignition fail ?
What is Traction? 1KVA Alternator, How much urrent taken?
how can i find cable size from current rating?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
what are problems caused by the pdu in rack server
What is the function of a neutral reactor.
why single CT used in DOL starter power circuit?
State thevenintheorem?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
How to decide whether A / B / C / D curve type MCB should be used?
