Interested to Buy Any Domain ? << Click Here >> for more details...
FRIENDS, I am doing DEEE (part time)final year. Give me
some ideas for project
- 5 Answers
- 9437 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / mahmud
U CAN GET SOME PROJECT DESIGN FROM VARIOUS WEBSITE(EEE
PROJECT DESIGN/ELSE).
U CAN TAKE A PROJECT FOR MAKING A
STOPWATCH,THERMAL/LIGHT/SMOKE/PARTICLE DETECTOR ETC.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
what is the working principle of a DG Set, Alternator, & exiter
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
Explain thin film resistors and wire-wound resistors
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
what is meant by 2 within a star in a voltmeter dial?
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
What is power relay?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
What descriptive information does the NEC require to be marked on all conductors?
