Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between SCADA and DCS?
- 5 Answers
- 16672 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / praveen kumar
SCADA is basically Remote area used, and its only data
gathering system and this system will depends on DCS for
controlling.
DCS is independent system, and this system will get
feedback and controlling also, SCADA can be added in DCS.
| Is This Answer Correct ? | 33 Yes | 3 No |
Post New Answer View All Answers
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
if in a level tx height is given, how u calculate the ranges of the tx?
what is diffrance between FF & SMART, explain with difination
what is the usage of QDV & VOLUME BOOSTER
What is the purpose of bypass valve across AS valve.
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
Why humidity limit is 30 to 55 % for raw material storage?
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
What is modbus?
please send the drdo exam paper
how to work MIL contol valve posistioner ?
Difference between dcs and plc including date processing and architecture.
what is temperature compensation?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Name different parts of a pressure gauge.
