Answer Posted / manoj tyagi
a xer, in which a part of wdg. is common to both the
primary wdg. $ secondry wdg.
in a 2 ,xer primary $secondry wdg r electrically
isolated,but in auto xer the wdgs r not electrically
isolated.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
What is Annunciation?
how the phase convertor changes the no. of phases
Do closed loop systems require manual input?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
what is under coal gassification?
what are the tests comes under the type test, what tests comes under routine tests.
How is operate breaker failure scheme in substation
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
what is tri state logic gate
Define load factor?
what is the difference b/w pvc cu conductor and cu breaded wire..?
List advantges of active filter over passive filter?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?