How can you justify a fully carged battery by physical
checkup ?
- 12 Answers
- 13352 Views
- Indian Military Services, I also Faced
- E-Mail Answers
Answer Posted / nidhi verma
it's easiest if u can arrange a voltmeter/ammeter. connect
a voltmeter/ammeter and note down the voltage/current.
compare it with the voltage/current ratings given on the
battery. if it's near about the given ratings, the battery
is fully charged else not...
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
we have 15 ampere variyac but we want 30 ampere variyac what we do
What are the advantages of speed control using thyristor?
What are the main advantages of bode plot?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
how braking & making capacity of circuit breaker is calculated?
I need bhel electrical test pattern & paper
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
how to calculate single phase motor efficiency ?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
Refernce currents are to be generated using refernce cueernts how can this be done
