Answer Posted / nitin bishoriya
PI stands for proportional integrator controller. In this
system input to a system is composed (SUM) of two signal.
One is the input that we applied and second integral of
feedback from output. Advantage of using PI is that steady
state error is reduced that is effectively not possible by
using proportional alone signal.
PID=proportional +integral +derivative of feedback from
output.
We we want to improve damping ratio besides improving error
signal then we use PID.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Define what do you understand by collector reverse saturation? In which configuration does it have a greater value?
I am working in a private software firm for past two years and now i want to switch to electronics company ... if they ask me ==>what I was doing for the past two years what would the appropriate answer to this ... please reply !
What is circuit switching?
Why silicon type transistors are more often used than germanium type?
how do link aT1 from the 1st BTS to 2nd BTS4?
How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?
what is difference b/w watt loss and watt full devices. what is watt loss and watt full devices?
Explain the various types of digital to analog converters?
why is the diffusion technique of formation of resistor most widely used?
is there any job for electronic engineering
What is intrinsic semiconductor ?
what Rx and TX power good RF conditions.
list the broad classification of adcs.
what do you want to join this bank
Explain the concept of frequency re-use.
