Interested to Buy Any Domain ? << Click Here >> for more details...
Why any transmitter signal is 4-20 mA only
Why is started from lower range 4 mA and upper range is
20mA.
- 5 Answers
- 12531 Views
- Edac, I also Faced
- E-Mail Answers
Answer Posted / p.v.srikumar
because if use 0 -20 mA as 0-100% there is any signal cable
damage or cable open it will show only 0%. if use 4-20mA as
0-100% it will show bad process value(live zero).
| Is This Answer Correct ? | 13 Yes | 9 No |
Post New Answer View All Answers
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
What is the use of gauge?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
why we are using magnet for calibration of gas detector?
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
what is scale factor of proximitor & unit of the vibration.
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
Explain the working principle of lvdt?
how to tune siemens sipart electro pneumatic positioner..plz tel me..
which type of signal used in instrument?
