what is dead weight tester and where it is used?.
- 11 Answers
- 18321 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / gopalkrishnan
Dead weight tester used for pressure gauge, pressure
transmitter, pressure switch calibration in high range.
(Kg\cm2or bar). it is used for industrial purpose in
instrumentation department.
| Is This Answer Correct ? | 32 Yes | 2 No |
Post New Answer View All Answers
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Draw block digram for well head from well to shipping pump?
What is modbus?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
What is the reason PT speed not incresed in gas turbine?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
Is there any relation between Artificial Intelligence and Instrumentation?
If fire would be inside the plant which fire detector is to detected the fire.
please send the drdo exam paper
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
what is the importance of CV in the control valves? how it is calculated?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
how to work MIL contol valve posistioner ?
