in trains i have seen the terminal which is connected at
the top of the train is positive .where is negative ?
track? i dont think so
- 9 Answers
- 8467 Views
- I also Faced
- E-Mail Answers
Answer Posted / rasiklal
Dear Ram,
In train return path for current is track only nothing else.
and in india we are using the same system for Electric
traction system. if you dont think so, so we can not change
the return path of current, pls chage your thinking ok
thanks,
WRB Engineer
Rasik Savaliya(GM)
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
specific difference of ICT&Auto Transformer
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
What is superposition theorem?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
Why can't we parallel the secondary circuits of two voltage transformers?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
Give some differences between open loop and closed loop?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
what about GD square and its important for motor design?
in 132kv substation CRT means
