Interested to Buy Any Domain ? << Click Here >> for more details...
Why is the earth pin in a 3-pin plug the longest and the
thickest?
- 10 Answers
- 30014 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / swadesh kumar singh
If there is a short ckt in the plug or line there is some
chance to damage the component or get shock & may fire.so
that earth ground is connected first for safety.
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
we need a ntpc previous papers
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what is reactive power?, why its measured in VA ? is it transient behavior of system?
What are the commonly used schemes for the bus zone protection?
How to decide and select the different earthing wire size for the different types of earthing
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
when will be the iocl interview results ifaced the interview on september 8 th
Why are the cores of large transformers built up of circular transactions ?
