Interested to Buy Any Domain ? << Click Here >> for more details...
7/20,3/20 electrical wire is specified as stated.Why?
- 1 Answers
- 17099 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / rachuri_sree
7/20 means 7 is no. of conductors and 20 is the gauge of
each conductor. It is old way of expressing the size of the
conductor.
| Is This Answer Correct ? | 72 Yes | 8 No |
Post New Answer View All Answers
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How to set the relay,,??
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
Define closed loop control system.
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Mention the disadvantages of low power factor? How can it be improved?
What we mean by vintage of an engine+Generator?
all details of DG UPS HVAC
define the non synchoronism of synchoronous machine in general g or m??
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
