What is the IP address of the switch?
Answer Posted / mvadivell
The switch can obtain its IP configuration automatically
using one of the following protocols:
?Bootstrap Protocol (BOOTP)
?Dynamic Host Configuration Protocol (DHCP)
?Reverse Address Resolution Protocol (RARP)
The switch makes BOOTP, DHCP, and RARP requests only if the
sc0 interface IP address is set to 0.0.0.0 when the switch
boots up. This address is the default for a new switch or a
switch whose configuration file has been cleared using the
clear config all command. BOOTP, DHCP, and RARP requests
are only broadcast out the sc0 interface.
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
Are Voice applications supported on this WIC?
Differentiate ethernet switch and a hub?
Explain what is routing table?
Is the PLUS feature set required?
Why is it that sms/mo receives a sent and delivered acknowledgement but mt is not receiving the message?
How can I utilize AAL2 support?
Is PPPoATM supported?
How does this WIC when installed into the Cisco 2600/3600 differ from the Cisco IAD2400 Series?
When will the ADSL WIC be available?
What market segment does the Cisco 1700 Series target with the ADSL WIC?
Is this WIC physically the same WIC that has been available on the Cisco 1700 series for some time?
Is PPPoE supported?
How is the Cisco 1700/2600/3600 with the ADSL WIC positioned in conjunction with the Cisco 827?
What is routing protocols purposes?
What are all the segments of routing ?