Interested to Buy Any Domain ? << Click Here >> for more details...
why we use only sine wave in ac why we do not use other wave
forms
- 21 Answers
- 51012 Views
- BARC, NTPC, I also Faced
- E-Mail Answers
Answer Posted / venu
i agree nd one more is for the fourier analysis it is the
best wave form which gives info abt harmonics etc
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is EMC filter in VVVF Drive ?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
what is the difference between directional & non directional earth fault with example please explain.
please send me privious exam's queation papers of section engineer(electrical).
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
diff b/w normal grounding and resistance grounding
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?
draw 3 phase rectifier diagram
what is POTT and PUTT explain?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
What about electrical Units. discrive in detail
