Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between SCADA and DCS?
- 5 Answers
- 16374 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / jeevana manickam
DCS- means Distribured Control systemm.This is mainly
process oriented system.If we ask the feedbeck from the
system,it will give from the IO field.This is a independent
control systen.
SCADA-means supervisory control and data acquisition
system.This is basically a data gathering system and given
the control based on that datas. This system will depends
PLC or DCS for its control.
| Is This Answer Correct ? | 58 Yes | 5 No |
Post New Answer View All Answers
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
What is the diffrence between digital signal processing and discrete signal processing?
what is the minimum power (P=VI)to produce a spark?
what is the calibration procedure for magnetic flow meter @ onsite
how to tune siemens sipart electro pneumatic positioner..plz tel me..
what is the difference between profibus and controlnet networking.
Calibration procedure for water rotameters
What is shielding effect?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
what is compensation? temprature & pressure
