Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ezhil.s
For Example :
75 KW convert to HP
75/0.746 = 100HP
| Is This Answer Correct ? | 73 Yes | 13 No |
Post New Answer View All Answers
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
why does rotor rotets?
how to convert lv line to hv line and viseversa, any losses will occur during this process
How do you determine the size of transformer radiators in a transformer?
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
Is there any guideline say about display of earthing value near to earth pit
In how we connect watt meter for open & short circuit test of a single phase transformer.
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
Why delta star trformers are used for lighting loads?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
What is the practical way to calculate the cable size for known ampere load?
