Interested to Buy Any Domain ? << Click Here >> for more details...
The administrator of a comapny needs to ensure that a web
server in
their network is accessible from the Internet. Since the
network uses private
addressing, this requires an IP-to-registered-address
mapping. The following
command is entered on the router:
router(config)# ip nat inside source static 192.168.2.1
198.18.1.254
After unsuccessful results from a ping to the Internet, the
administrator issues the
show ip nat translations command and the output is blank.
What could be the
problem with the NAT configuration for this mapping?
A. The keyword overload is missing from the command.
B. The administrator needs to define a NAT pool first.
C. An access list must be defined to create static NAT
translations.
D. The interfaces need to be configured for NAT.
- 4 Answers
- 7933 Views
- I also Faced
- E-Mail Answers
Answer Posted / shahin
Hi Jitendera, One question regarding VTP.
After all configuration, do i hv to go to each switch &
configure each port manually or ya on VTP server i cud do
this. I mean assigning interface to VLAN.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Mention what is the difference between dynamic ip and static ip addressing?
How many fillers we can put in one ip of ipv6?
Define load balancing?
Explain the types of nat?
Which defined peer ip address an local subnet belong to crete?
Explain dhcp scope?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
What is the size of hello packets in eigrep protocol?
What is a network subnet?
Mention what does the clock rate do?
Which cable we connect in db-9?
Which protocol you manually enable route summarization?
What is the network brouter?
How is rip different from igrp?
In which access- list type you can't do editing?
