The administrator of a comapny needs to ensure that a web
server in
their network is accessible from the Internet. Since the
network uses private
addressing, this requires an IP-to-registered-address
mapping. The following
command is entered on the router:
router(config)# ip nat inside source static 192.168.2.1
198.18.1.254
After unsuccessful results from a ping to the Internet, the
administrator issues the
show ip nat translations command and the output is blank.
What could be the
problem with the NAT configuration for this mapping?
A. The keyword overload is missing from the command.
B. The administrator needs to define a NAT pool first.
C. An access list must be defined to create static NAT
translations.
D. The interfaces need to be configured for NAT.
- 4 Answers
- 6736 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera kuaar sinha
thanks sahin
onse you posted a qustion on tha web site is that you got
same vlan information on two diffrent switch which is
configured as server nad clent
now here is the best naswer of that prob
today i also faced same prob when i croos check the all the
confregation then i see that i configure same domain name
on both switches as i rename one switch in diffrent doman
name problem has solved
so i think it might be possible that you have done same
mistake.
plz check it
and agin thanks for that sol^n becoz i was trying to solve
that prob from last 3ree days and i was just forget the
most important thing about nating how fool i am
thanka again
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Utilizing RIP, what is the limit when it comes to number of hops?
How many ports are present in a router?
What is ‘round-trip time’?
Name the protocol which can do load balancing on unequal cost also?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
Mention what is the difference between tcp and udp?
Explain the difference between simple authentication and md5?
What is the difference between csma/cd and csma/ca?
What is the working of router?
What are the two types of transmission technology use in ccna?
What are the protocols that are used by every layer of ip/tcp model?
What is the difference between unicast, multicast, broadcast, and anycast?
What are the three sources of signal degradation on a data link?
What is BootP?
Which cable called v.35?
