Answer Posted / srinivasarao mogalikuduru

Interrupt vector table contains address locations for
different types of interrupts like type0,type1, etc.
Type 0, type1.. these are defined for different
interrupts. When particular interrupt encounter by CPU then
CPU calls those vectore address locations as sub program
and execute it.Then those interrupts are rectified.

What are the different types of flip-flops?

1024

---

what do you mean by quasi fermi level?

6187

---

What is the chemical composition of the substance used as feed horn? And how many types of feedor are there?

2089

---

What is the difference between race and race around condition

2180

---

Explain why the aspect ratio of tv video display is 4:3 or 16:9?

951

---

What is point contact diode?

966

---

GET-2013 exam is going to be held on which day(tentatively).

1967

---

what is difference b/w watt loss and watt full devices. what is watt loss and watt full devices?

2292

---

sir, I completed B.E in Electronics and Communication Engineering and ME in Embedded System Technologies. I want to work as a lecture in Government Polytechnic College. Please give the model or previous year question paper.

2285

---

write a c programme for add of two numbers with out use of arthematic operators

1871

---

Define what is meant by operating point?

980

---

We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?

1956

---

why should you consider youself fit to be hired by jspl

1927

---

draw a ckt diagram i/p 230v & o/p 80v??????

2440

---

Dear concern Plz provide me the solved papers of Railway section engineer in signal...

1881

---