will we have to design the UPS differently for both i.e. if
we want to connect the two batteries in parallel and/or we
want to connect the two batteries in series ?
- 4 Answers
- 5297 Views
- I also Faced
- E-Mail Answers
Answer Posted / aamod tripathi
OBVIOUSLY THE AMPERE HOUR CAPACITY AND THE INPUT VOLTAGE TO
THE UPS WILL BE DIFFERENT IN BOTH THE CASES THUS U WILL
HAVE TO DESIGN DIFFERENTLY FOR BOTH
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the basic need of domestic loads 1- voltage 2- current
What current position are you holding in your current company?
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
Draw transformer phasor diagram.(full load,no load)
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
Z transform is use when system is not a) converges b) diverges
What are the advantages of skewing of cage rotor conductors?
What is tranformer differtial?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
sir i want previous entrance exam papers for written test
what is kvarh? Please define it With calculation General motors ?
When we giving the 3 phase supply to ups system how to coming netural?
IN 1000kva transformer where the oil and winding temperature sensors is connected
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Electrical Engineering
