in a 740 kw dc seperately excited motor field voltage is
constant about 17.4 volts and armature voltage is500 volts
dc.
how it is possible to have two different voltages from
single transformer of output voltage 500 volts?
if any difficulty in question contact
ajitsingh.kadian@gmail.com
- 1 Answers
- 3810 Views
- I also Faced
- E-Mail Answers
Answer Posted / aamod tripathi
BY USING TWO SECONDRIES
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
What is the exact minimum vale of voltage between an earth and netural which can damage or can do malfunction of the electronic equipments ? If this is mentioned in any book, pl.give reference.
What is the cut-off rate?
how to handle 2500 kva transformar
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
what is the difference between surge protection capacitor and surge arrestor
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
what are the analog quality input for protection function?what are minimum reqiments?
Compare jfet’s and mosfet’s.
How much load can take a 16 mm aluminum cable 3 phase
why fractional pitch winding generally used in alternators?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
electrical
what is the purpose of using filters in a protective relaying scheme?
