Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of the shield wire and how is the
connection at both the ends of a shield wire?
- 2 Answers
- 8843 Views
- Samsung, I also Faced
- E-Mail Answers
Answer Posted / mh ravi kumar
With Shield cable required for Analog and RTD signals.
Panel or JB side shield to be earthed but Instrument side
no need to do earth (cut the shield and taped).
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
What is standard procedure of manual mapping in Radar type level transmitter?
how to turbine speed measurement?
can you provide me full detail about instrumentation in ONGC??
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Explain the difference between plc and cnc?
which type of signal used in instrument?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
what is the process to make control schematic ?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
What is the difference between modbus,fieldbus & profibus
what will the sending unit in the fuel gauge utilizes?
