Interested to Buy Any Domain ? << Click Here >> for more details...
why reinforcement is not provided at centre for beams r column
- 9 Answers
- 29919 Views
- I also Faced
- E-Mail Answers
Answer Posted / miidangriika
Why do we provide steel to the concrete, is it not for
taking tension as concrete can take only compression.
As we know that the maximum tension takes place on the
outer face of the beam or column, therefore the the steel
is provided to the outer face of the beam or column.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
Where will be the maximum bending moment in a TEE Beam?
Minimum concrete cover in slabs, columns, beams, foundation and other st?
What are the phases inspections are done by local authority while construction?
on what basis the partial factor of safety are decided? form the load combinations
What is the strongest bridge for a school contest?
Why are steel plates inserted inside bearings in elastomeric bearings?
5. Do you feel that your present employer estimates your full work potential? Are they pleased with your work performance?
Which is the direction of negative angle?
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
What are the methods in tiles flooring ? What are the methods in brick work? What are the methods in plastering ? What are the methods in wall tiling?
How to do base isolation using ETABS software?
What is the difference between Fe 500, Fe 500 D and Fe 515.
Labor requirement for each item needed? Lean Concrete 103.550m3 Concrete for Foundation and Structure 1753.000m3 Expansion joint 288.000m Contraction joint 127.000m Dowel bar 450.000m
