can u please tell me how VFD(variable frequency) drive is
used as a energy saver....?
- 12 Answers
- 17371 Views
- Essar, Oracle, I also Faced
- E-Mail Answers
Answer Posted / sivaraman
ofcourse by vfd v can control speed. but if v use t 4 enrgy
consumption y dont v go for low speed(i.e low rated)motors
instead using a high rated one n to reduce its speed by
vfd. so its used onli to speed control not in the point of
view of energy saver. for that we can use capacitor banks
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
What is the difference between diode and a transistor in terms of the direction of current flow?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
Which type of transformer is used for lighting loads?
how to calculate cooling requirement of datacentre from electrical load?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
Formulae for calculating the transmission line losses for different voltage levels
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
Why the efficiency of generator is more than motor in swinburne's test
List the disadvantages of constant k filters?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
what is the terminal voltage of dc series generator running at rated speed at no load?
