Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between single phase and three phase
- 6 Answers
- 10331 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhanesh
in single phase, voltage is measured between the Neutral &
Phase is 230 V while in 3-Phase voltage measured between two
phases is 415 V. 3-Phase having a 2-types of connection
,(1) Star and (2) Delta.
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
how can i improve the power factor in domestic (230v)
Which type of motor is used in trains, what is the rating of supply used explain working principal?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
Why is back emf used for a DC motor? Highlight its significance.
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
can some one clearly explain why -48 volt DC use in telecom site????
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
What is the technical difference between On delay timer and a Star delta timer?
what is a bus riser in power system and why it is used
i need about 10 years of GATE solved papers in pdf format and even mock tests toooo
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
how to calculate the fault in substation
what is the efficiency of thyristor
