Interested to Buy Any Domain ? << Click Here >> for more details...
here is your question sahin
Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight
is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1,
K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP.
I knew about it from ICND 2 cisco press book.
Three more questions -
a) If we change the K value (I mean metric weight)on a
router what will happen???
b) When redistribution is necessary in EIGRP. Is there any
condition for that???
c) What is reference bandwidth for metric calculation in
EIGRP. As we know, in OSPF, on a CISCO router reference
bandwidth is 10Mbps.
- 3 Answers
- 6572 Views
- I also Faced
- E-Mail Answers
Answer Posted / jietendera kumar sinha
hi sahin
i was expecting that u know all that thing which i described.
ok tell me what is real problem i will try my best to explain yours confusion.is the three are yours real question then one thing remember that only badwidth and delay is used in path determination one term i wlll refer to say that composite matric.ok changing the value of k effect changing the value of matric.but it can be done by two way as i described in my first
section of answer.if you have still some confusion then mail me on jitenderasinha.it@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the protocols that are used by every layer of ip/tcp model?
Tell me how much hold down time of eigrep protocol?
Name the vtp modes?
Mention what is the difference between dynamic ip and static ip addressing?
Does a bridge divide a network into smaller segments?
Explain the benefits of VLANs.
Explain the term 'multicast'.
Explain the benefits of vlan?
What is a network subnet?
Which company mange ip's?
Explain dhcp scope?
Name the protocol which can do load balancing on unequal cost also?
What is the difference between half duplex and full duplex?
What requirements should a VPN fulfill?
What route entry will be assigned to dead or invalid route in case of RIP?
