Interested to Buy Any Domain ? << Click Here >> for more details...
What is the rating of HT SUBSTATION and LT SUBSTATION?
- 11 Answers
- 57084 Views
- NTPC, Sail, I also Faced
- E-Mail Answers
Answer Posted / sukhvinder
HT (High Tension) substation means if substation is
suppluing power to another substation is called HT
substation.(800/400/220kv,220/132 KV,132/66kv)
LT (low tension)substation means if substation is supplying
power to domestic and industrial usage is called LT SS. It
rating for domestic (66/11/440/0.240 KV) for industrial
(132/66/33) KV.
| Is This Answer Correct ? | 11 Yes | 7 No |
Post New Answer View All Answers
how to extend relay operating timing in 24V dc relay card (without using Timer )
what is difference between bus coupler and auto transfer switch
what is the voltage rating of chiller unit sensors
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Why neutral is not used in three phases dol starter
What is meant by reset level of the relay?
A low wet bulb temperature indicates
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
When MICC cables used ?
what is the maximum temperature rating of a thhn insulated conductor?
Electrical 'C' license full abbreviation , and full form
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
what is the Connected Load (kW) or Contract Demand (kVA)of mahindra nasik plant??
