Interested to Buy Any Domain ? << Click Here >> for more details...
here is your question sahin
Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight
is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1,
K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP.
I knew about it from ICND 2 cisco press book.
Three more questions -
a) If we change the K value (I mean metric weight)on a
router what will happen???
b) When redistribution is necessary in EIGRP. Is there any
condition for that???
c) What is reference bandwidth for metric calculation in
EIGRP. As we know, in OSPF, on a CISCO router reference
bandwidth is 10Mbps.
- 3 Answers
- 6656 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera kumar sinha
hi sahin.now i am trying to giver your
all three question but one thing is
necessary to know that what is default.
default is that which can be configurable.
now in the eigrp determination of path
done by cost. that is cost==10^8/bandwidth
now the path which have best cost is
selected as best path that is the path have
lower cost selected as best path.
one point is noticeable that eigrp use only
bandwidth and delay to path calculation .
mtu is never used for path calculation but
it is a important parameter for eigrp
related command. how to configure bandwidth
of eigrp Set the bandwidth on your
interfaces using the bandwidth
command
Router (config-if)# bandwidth XX
(if you want bandwidth 5600 simply write 56 not 5600)
this is the command by which you can configure your bandwidth now back to your first question
. 1 now you are going to change the metric
value that is "k" the what happen here is the
answer k=ad value/bandwidth(Wright)for eigrp
ok ad value is constant(let) now
you can change only bandwidth value now as
we discus earlier that path determination
is based on bandwidth so as you increase
the bandwidth cost decrees then it will be
selected as best path.
and if you decrease then cost increases
then it kept in to routing table.
Now your second question’i have written
earlier that to reduce routing overload
we need redistribution
in another way we can say that in the
large network we need redistribution.
Now yours 3rd questions
Frankly speaking I don’t know
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the default bandwidth size of t1 routers?
What is the minimum request timer?
Explain how many broadcast domains are in switch?
How many valid ip will b in /21 in route summarization?
Define the different kinds of casting
Why subnetting is used?
What is the maximum value of administrative you can use?
Utilizing RIP, what is the limit when it comes to the number of hops?
Can you explain encapsulating, carrier and passenger protocol?
Is hub intelligent device?
Explain what is formula of hold down time of eigrp protocol?
Define the virtual channel?
What is the difference between an igp and an egp?
in stead of 0.0.0.0 wild card mask what u can write after ip?
How many tables are in ospf protocol?
