Interested to Buy Any Domain ? << Click Here >> for more details...
Hi Guys i hv one confusion. Need u peoples help.
In EIGRP, maximum hop count is up to 255. By default only
100. Now question is -
a) Suppose i hv a network consist of 115 routers & EIGRP
routing protocol is configured. By default hop count is 100,
so is there any manual configuration necessary for hop count
ya router will automatically detect the hop count & will
update the hop count accordingly..?????
b) In EIGRP, Bandwidth & Delay is used to calculate metric.
For this Metric weight is set to K1(Bandwidth)=1,
K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0
Now i want, Bandwidth & Load is used to calculate metric.
For that wat i hv to configure & wat wub the metric weights.
Cud anyone explain it plzzzz..!!!!
- 5 Answers
- 7293 Views
- I also Faced
- E-Mail Answers
Answer Posted / mr.shahin07
Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight
is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1,
K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP.
I knew about it from ICND 2 cisco press book.
Three more questions -
a) If we change the K value (I mean metric weight)on a
router what will happen???
b) When redistribution is necessary in EIGRP. Is there any
condition for that???
c) What is reference bandwidth for metric calculation in
EIGRP. As we know, in OSPF, on a CISCO router reference
bandwidth is 10Mbps.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How we can see mac address from dos prompt?
Which command we give for see routing table?
How many fillers we can put in one ip of ipv6?
What is the maximum request timer?
What is size of ipv4 mac address?
How many hop counts are by default and how much you can increase in eigrp protocol?
What are some standards supported by the Presentation layer?
Tell me which cable we connect in db-9?
What are the different memories that are used in a cisco router?
What are the ranges for the private ips?
When ospf protocol advertise its routing table?
What is the difference between tracert and traceroute?
What is icmp protocol?
Why we use debug command?
Explain dhcp scope?
