Interested to Buy Any Domain ? << Click Here >> for more details...
why we use to transmit the power in three phases intead of
single phase ?
- 5 Answers
- 9415 Views
- I also Faced
- E-Mail Answers
Answer Posted / shirish
1.generation efficency increased
2.less copper conductor is used for 3 phase power generation
as compared to 1 phase power generation.
3.more efficiency of eqvipment as compared to 1 phase
| Is This Answer Correct ? | 13 Yes | 2 No |
Post New Answer View All Answers
what is plunger and what's the use of it in motor alignment?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
what is parellel power factor correction?
When is lag lead compensator is required?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
HOW TO CALCULATE THE VT SIZING?
What are differences between Voltage, EMF & Potential difference ?
what is through fault?
How work of capacitor in dc supply...???
