What will happen if I apply DC to AC transformer? please
send detailed answer at habib_rahman_habib786@yahoo.com
- 4 Answers
- 10623 Views
- I also Faced
- E-Mail Answers
Answer Posted / glen saldanha
it depend whether it is dc pulsating or pure dc waveform
as transformer is a reacive load whose formula is
Xl=2phi f L
In pure dc the frequency is zero so it is as good as a
short circuit but in case of pulsating dc as frequency is
known it will definately produce a dc pulsating at the
secondary of the transformer output.Example in SMPS of your
computer these transformer are used.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
what is the cause of voltage dipp or swell in the transmission lines?
Write the analogous electrical elements in force current analogy for the elements of mechanical translational system.
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
Which is the largest hydropower station in the world?
what is lumped and distributed elements?
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
Why is a plain induction motor unsuitable for wide speed control?
Explain cmrr?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
what's the exact magnitude of current, flows through Neutral?
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
