Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT REASEAN USE TRANSMETER TWO WIRE & FOUR WIRE
- 5 Answers
- 12951 Views
- Kentz, I also Faced
- E-Mail Answers
Answer Posted / giridharan
mostly in industry of petrochemical we will use only 2 wire
in which power and signal
actually signal will be 4-20 ma
power will be only 24 v so as it will send and same will
recieve it.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
what are the use of belew gear in general ??
How to calibrate an pressure gauge with yantrika test bench?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
what is IEC code in cables & how to selecting cables?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
What is eddy current? Describe the operating principle of proximity probe.
how to measure draft pressure in transmitter pl. give its single line digram
How does temperature bath work? How does coil gets heated only by applying some current?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
how the arrangement of equipments done in control room
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
