Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / irfan khan
pt is the pottential transformer which uesd for measurement
of voltage as well as control supply also.the high voltage
can not be measure directily , e.g. incomer voltage is 132
kv so we put the bus pt of 132kv/1.732/110 volt /1.732 for
6.6 kv voltage measurement . the voltage of primarry and
seconderry may be vary acordingly.gernelly the seconderry
of pt voltage is 110 volt or 220 volt AC. so seconderry
voltage can be used measurement as well as protection.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Why you want to join non technical field when you are an engineer?
i want to know that how the height of Ct ,cvt ,LA calculated on the basis of creepage distance
how we can set the IDMT relay.
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
what is the best transformer oil breakdown voltage?
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
How to calculate the Efficiency of Chiller
Name two low frequency oscillators?
What is control system?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
Sir, I m 3rd year student 4m DCE and want to do internship in siemens or l&t or any other mnc related to electrical engineering. please tell me the procedure 4 same and oblige me
Mention the disadvantages of low power factor? How can it be improved?
