Interested to Buy Any Domain ? << Click Here >> for more details...
What is RTCC panel and why it is required
- 31 Answers
- 135422 Views
- RTCC, Tivoli Grand, I also Faced
- E-Mail Answers
Answer Posted / perservance
RTCC means relay tap changer circuit,these are the relays
which give command to the tap changer present in the
transformer H.T side to either increse or decrese the tap
since due to inductive load ( lagging p.f ) , the secondary
terminal voltage would decrease which would not be good for
the loads so by chnging taps, we increase the primary
voltage which in turn changes the secondary
voltage,normally done online.
| Is This Answer Correct ? | 235 Yes | 74 No |
Post New Answer View All Answers
What is the formula to calculate distribution transformer De-rating on iron losses basis
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
Control wiring of a dol starter for forward and backward
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
What facility we get after CT secondary earthing and how?
what is the constructional difference between a power transformer and potentian transformer?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
what are the specifications we must look at to select a relay for any capacity motor?
How to find out damper winding failure for synchronous machine?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
How to set a Zone 1 distance relay for distribution feeder?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is CCT (Correlated Color Temperature) ?
