Interested to Buy Any Domain ? << Click Here >> for more details...
how to select the power contactor in Diffrent AC motors.
- 6 Answers
- 26511 Views
- Titan, I also Faced
- E-Mail Answers
Answer Posted / navnit bhimani
Motor full load current=H.P.x1.5 in three phase line
Motor full load current=H.P.x4 in single phase line
you can select 20% over size than full load current.
| Is This Answer Correct ? | 30 Yes | 8 No |
Post New Answer View All Answers
give single line diagram of D.G distribution form alternator to main L.T panel?
pls tell us AC plant are how do work and parts name with picture
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
why the check zone and main zone are used for Busbar Protn. scheem?
how will we calculate the copper wire load..
What is synchro?
What is the universal motor?
difference between the applicability of nortons and thevenin theorem
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
What are the three major categories of error?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
