why generator and t/f ratings given in kva & motor rating
is in KW?
Answer Posted / navmit bhimani
In transformer there are two losses,copper loss depend on
current and iron loss depend on voltege and nothing
relation with power factor.so and so....
Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
How they LT panel busbar size choose
how is control wiring coding is done in a CRP panel ?
how 650 volts creates? where is use?
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
How to decide DO set rating of Transformer?
Why is the frequency not changed during transformation of electrical energy in a transformer?
Comment on the working principle of operation of a single-phase transformer.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.