Interested to Buy Any Domain ? << Click Here >> for more details...
how checking is done in fiber optic cable?
explain the working of RTU?
- 5 Answers
- 16409 Views
- PSU, I also Faced
- E-Mail Answers
Answer Posted / jignesh
optical fiber cable is transmit the signal in form of
light,it will be measure such a instrument is OTDR .
RTU - stand for remote terminal unit . it collects all data
from the field , in field numbers of rtu is availble and
send a signal to one MTU. MTU is stand for Master Terminal
Unit which give signal to scada computer is Supervisory
Control Data Aqusition system.
| Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
What is the diffrence between ff tx and non ff tx
What is the use of temprature compensation?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
why we r opening HOT BYPASS valve during startup of a compressor?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
what is performance test.need defination
List three types Level Switches with their working principles
What you mean by multi stage control vavles?
If P will increase then what will happen with PID?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
What are the interlocks we have to check during the start up of LP/HP compressor?
How many types of sensor
