What is the most common layer 2 device?
A. Hub
B. Router
C. Switch
D. Repeater
Answer Posted / willie redic
c switch
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
Define the multicast routing?
What is the command for change serial cost?
Differentiate full-duplex from half-duplex.
How do you configure a Cisco router to route IPX?
What is difference between igp and eigrp?
What is the difference between hub, switch, and router?
What is DHCP stand for?
What command do we give if router ios is stucked?
Why we use debug command?
In port based access-list which command you give instead of ip?
Can you explain the broader steps of how L2F establishes the tunnel?
hi shain can u send me some detail about bgp so that i can enhance my knowledge over bgp and can you also teach me about the process of suppernating. now what i am thinking that this could be last visit on that site overhere.so please mail that short of thing on my gmail id i am requesting to all of the visitor that please send theire doubt or question to my new gmail id which is jitendera.ccnainterview@gmail.com.i will try to solve it if i am capable to do it Wishing all of you for great future Jitendera kaumar sinha
What is the checksum?
What command do we give if router IOS is stuck?
How many fillers we can put in one ip of ipv6?