Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sumit mishra from areva t&
Protection required for dectection of abnormal(fault) condn
in case of generator are called generator protection.
Proetction req is based on the rating of the generator.
Following are some protection req in case of Generator.
1.Under/over voltage
2. Under/Over freq
3. Reverse Power
4. Differential Protection
5. Voltage controlled/restrained O/C
6. Loss of Filed
7. Stator E/F
8. Rotor E/F
9. Negative sequence/unbalance
10 Pole slipping etc..
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
why impudance relay used for medium transmission power system? why not others?
what is the principle of operation of CFL ??
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
What are the advantages & disadvantages of a group electrive drive?
what are the problems that generally occur in power flows??
What is the reason that the humming sound is coming from the induction furnace panel?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
how many joints are allowed in underground HT cable of 1 KM
