Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body tell me what is use of END OF LINE RESISTOR in
fire alaram circuit?
- 2 Answers
- 7217 Views
- I also Faced
- E-Mail Answers
Answer Posted / kevin hackart
THE END-OF-LINE RESISTOR IS USED IN MOST ALARM SYSTEMS AS A
CABLE FAULT MONITORING DEVICE, EG.CABLE CUT BY INTRUDER.
THE MAIN CIRCUIT USES A SPECIFIED RESISTANCE AND THE MOMENT
THAT VALUE ALTERS OR DISAPPEARS IT TRIGGERS THE ALARM. ALSO
WHAT COULD BE USEFUL IN FIRE ALARMS IS IF THE CABLE IS
BURNT OFF OR HEATED THUS CHANGING THE RESISTANCE FURTHER
DOWN THE LINE IT WILL ALSO TRIGGER THE ALARM AND COVER FOR
A FAULTY DETECTOR. MAINLY THE RESISTOR IS FOR TAMPERING AS
MOST SYSTEMS USE A NORMALLY CLOSED LOOP AND SO IT IS EASY
FOR SOMEONE TO JUST SHORT OUT THAT CIRCUIT WITH A PIECE OF
WIRE, A SPECIFIC RESITANCE MAKES IT TOUGHER TO BE BYPASSED.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What facility we get after CT secondary earthing and how?
What's the difference between non break power supply and non break non short break power supply
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
how to decide choke rating for drive?
gas turbine genrator reactances
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
how we calculate the withstansing current capacity of wires&cables?
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
how to measure the current by compact digital equipment with dislay which fit inside any equipment
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
How to calculate mf when meter equipment and meter are connected
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
