Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthick
Bearing is used to provide relative motion between two
parts without friction.In general,it is better to have
rolling contact or any sort of contact rather than sliding
contact.Because sliding contact gives more friction.At this
juncture bearing is used
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Explain the difference between the points of inflexion and contraflexure?
why does polytropic efficiency of a compressor decrease with increasing flow rate ?
What is the sensitive part of the liner
Differentiate between the uniform flow and non-uniform flow?
What are the modes of heat transfer?
What s gland sealing steam?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
As per api 650 code for new ss tank fabrication,in bottom plate bulge is acceptable? How many bulge acceptable for api 650?
What is the critical speed. Compare the critical speed of hollw shaft and solid shaft.
what is the technology used in sap?
What is a radial-flow turbine?
hi sir my name is srikanth plz send me question papers
What are the advantages of dtsi over normal engines?
Is Solid work and solid edge best programs for drawing? what is the difference bewteen them? r there better softwares?
What is the difference between air conditioning and refrigeration?
