What is the acessaries distribution transformer ?
- 11 Answers
- 16419 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / khilendra pant
the acessaries distribution transformer is:-
1.breather filled with blue
silica gell
2.Conservator with top cover
3.core
4.core channel and base channel
5.cotton tape and webbing tape
6.lv and hv coils
7.runner and dove tail runner
8.earth foil
9.MPC wire
8.kraft paper
9.transformer oil
10.press board
11.tie rod
12.clamping rod
13.muts and bolts
14.BUCHOLZ RELAY
15.pressure
relief valve (PRV)
16.hv busbar, lv busbar,i.
e incoming & outgoing terminals
17.RADIATORS
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What Is Connection APFC Panel In Compony.
whatis the commertial spec. of distribution boards ?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What is the use of lag compensator?
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
How is operate breaker failure scheme in substation
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
Difference between rating factor of cable and derating factor of cable?
Explain RLC circuit?
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
Details about Flux Compensated magnetic Amplifer starter for motors
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
why core is useful for a transformer ?and also in its operation ?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
