Interested to Buy Any Domain ? << Click Here >> for more details...
any body tell me ,contol valve has how many cheractristic?
explain it.
- 6 Answers
- 11215 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / nidhi
control valav has mainly three characteristic
1. linear
2. quick opening
3. Equal percentage
| Is This Answer Correct ? | 47 Yes | 1 No |
Post New Answer View All Answers
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
principle of automatic votage regulator
what is the difference between profibus and controlnet networking.
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
Why thermo wells are used? What materials are used in thermo wells?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is the purpose of bypass valve across AS valve.
