Interested to Buy Any Domain ? << Click Here >> for more details...
How one can check the charger of the mobile phone or any
other charger .......... that is it working ? if , working
is it delivering the required supply which is needed by the
battery to charge properly ?
- 4 Answers
- 10130 Views
- I also Faced
- E-Mail Answers
Answer Posted / dineshdesh
what to check from multimeter i.e. current, voltage,
resistance etc ? and how ?
thanks
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
placing earthing pit in pathway is correct or wrong??. placing earthing wireGI1/18 inside walls is correct or wrong?. explain!!!
What is I to C?
How stabilizer works??
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
what is conductor copnstant of ab cable
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
what things to be considered when designing UPS
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
In radial network the source is fed from 1 end both ends at central
how to measure earth resistance of a substation
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
why we testing the core balance of the transformer before comissioning?
