Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rahul saha
hub can be controlled through program and setting
instructions but not generally manual,
switch are generally mechanically / electrically controlled
device.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How the warning lamp of a charging-system is activated ?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
if my flow is 20000 m3/h than which range of DPT i have to use????
what is the imbustion control loop
What is Positive Calibration and Negative Calibration?
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
which type of signal used in instrument?
hi! i want to know about mpse exam.
What are the interlocks we have to check during the start up of LP/HP compressor?
What is mean by analytical instrumentation?
How can you add value to this Industry if offered the job?
What is intrinsic safety mean.
protection relay watchdog contact operation?
