Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ankush dhiman
speed is directly proportional to the cube of power. 20%
speed is reduced,50% is the power saving.vfd will be
suitable as per custmor uses.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
What is negative sequence over voltage element?
what is the difference between circular wdg & ractangular wdg?
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
How to Calculate the Fault Level of Electrical Installation
how to remover corona effect and hysteresis losses from contactor
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
where are the circulat the diesel in DG parts name with pictue
my b-tech percentage is 50%. what answer will satisfy the hr ?
how to calculate the size of the HT cable
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
