Which two of the following are valid ways to have multiple
encapsulation types on a single interface?
A.) This is not possible
B.) subinterfaces
C.) additional physical interfaces
D.) secondary addresses
- 2 Answers
- 4614 Views
- I also Faced
- E-Mail Answers
Answer Posted / rd_bharwani
It would be only B...
which would creat a subinterface
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the maximum request timer?
What route entry will be assigned to dead or invalid route in case of RIP?
How do you go to privileged mode? How do you switch back to user mode?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Which mode called privilege mode?
What are the different types of passwords that you can use in cisco routers?
What is half duplex and full duplex?
what is prefix list
what does PPTP use for encryption and authentication?
Which command we give on privilege mode for coming back to user execution mode?
What are the protocols that are used by every layer of ip/tcp model?
What is the function of the Application Layer in networking?
On which mode we give debug command?
Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?
What is STP and what is the difference between PVST and RSTP
