Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mahantesh
Three phase carry large current than a single phase current,for larger loads the cross section of conductor is larger in single phase than three phase and single phase cannot be transmitted to larger distance than the three phase,line losses are small as compared to single phase so we prefer three phase instead of single phase
| Is This Answer Correct ? | 15 Yes | 5 No |
Post New Answer View All Answers
Convert a star connected network into a delta connected network.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
What is the unit of charge and current?
Comment on the working principle of operation of a single-phase transformer.
what rectifiers is and what are the types of rectifiers?
What is the effect of positive feedback on the stability of the systems?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
how is control wiring coding is done in a CRP panel ?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
how to select the no. of brushes in a lap winding?
How do apply electrical 'c'license......pls advice
what is the difference between gas group b and gas group c electrical equipment construction wise?
