Interested to Buy Any Domain ? << Click Here >> for more details...
why we use to transmit the power in three phases intead of
single phase ?
- 5 Answers
- 9256 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradeebha
1.in case a fault occurs in a line ,unlike single phase the
continuity of power supply will not be affected i.e the
other two lines of 3 phase will not get affected.
2.single phase loads can also be operated by connecting it
between line and neutral.
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
sir vizag steel ka junior trainee ka paper kitne number ka ayega
What is negative sequence over voltage element?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
What do you mean by dependent and independent voltage sources?
what is transformor oil gread
why power not passes in plastic and rubber material
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
High speed earth switch operation with diagram
HOW TO CALCULATE THE VT SIZING?
