if we appling capacitor at above rated what are looses
and what will be happen
Answer Posted / felixraj
current leads the voltage this reactive(lead) losses is much
sever then lag losses
source acts as load
alternator AVR loss their control and voltage increases
abruptly.
tks
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
how to carried out tan delta test in 11 KV alternator ?
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
Explain few advantages of electric traction system?
how we provide neutral earth on synchronising panel as per electrical standards?
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
what is capacitor voltage transformer?? how it is different from potential transformer?
How a band pass filter is constructed?
Where is servomechanism used?
what is Anti-pumping?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA