Answer Posted / ravikumar josyula
AH capacity of the battery is the current required to
discharge the battery from its full charge voltage to full
discharge voltage and the time taken to do so.FCV of a cell
is : 2.2 or 2.3 volts , FDV is :1.9v.
If we know the no plates of a battery then can calculate
the capacity as above. Otherwise full charge it and the
discharge it to full discharge voltage.mutiply the time
taken to get fully discharged in hours and the current
drawn in amps.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What are the advantages of speed control using thyristor?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
what is DRP panels?
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What is Bolted fault?
why we are using Load factor?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
What is Annunciation?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
Mention the disadvantages of low power factor?